Logo

P3618 Engine Code Repair

Meaning of P3618 engine trouble code is a kind of powertrain trouble code and when the check engine light comes P3618 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

P3618 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P3618 code is occuring now you should check P3618 repair processes.
Now don't ask yourself; What should you do with P3618 code ?
The solution is here :

P3618 Possible Solution:

P3618 Engine

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

P3618 Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

3
Ignition System Or Misfire

6
Fuel Composition Sensor Circuit Malfunction

1
Cold Start Injector 1 Malfunction

8
Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P3618 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P3618 engine trouble code is about Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical.

Main reason For P3618 Code

The reason of P3618 OBD-II Engine Trouble Code is Fuel Composition Sensor Circuit Malfunction.

P3618 DTCs may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.